Epson Stylus PHOTO 890 Service Manual page 157

EPSON Stylus Photo 890/1280/1290
Table 6-2. Lubrication Point
Lubrication Point
1 COMBINATION GEAR, 12, 22.92,
LEVER ASSY
• Using a brush, apply the grease evenly to
the inside surface of the bushing except
for the part in witch E-Ring is installed.
2 BUSHING, 12, RIGHT
• Using a brush, apply the grease evenly to
the inside surface of the bushing.
3 HOLDER, PULLEY, DRIVEN
4 BUSHING, 12, LEFT
• Using a brush, apply the grease to the
inside surface of the bushing.
5 BUSHING, 6
• Using a brush, apply the grease to the
inside surface of the bushing.
6 PULLEY, DRIVEN
• Apply the grease to the flat surface.
7 SHAFT, PULLEY, DRIVEN
8 COMBINATION GEAR, 12, 22.4
• Using a dispenser, apply the oil to the
entire inside circumference of the gear.
9 COMBINATION GEAR, 14, 28
• Using a flux dispenser, apply the oil to the
entire inside circumference of the gear.
10 Shaft C
• Using a brush, apply the oil to the whole
surface of Shaft C with G-26.
MAINTENANCE
Lubricant Type &
Refer to:
Amount
G-26 Page 159
G-26 Page 159
A 3-mm wide bead
G-26 Page 159
φ
1 x 3mm (for each of
the 4 points)
G-26 Page 160
A 3-mm wide bead
G-26 Page 160
A 1-mm wide bead
G-26 Page 161
φ
1 x 1mm (2 points)
G-26 Page 161
φ
1 x 1mm
O-12 Page 161
O-12 Page 161
Page 161
Overview
Table 6-2. Lubrication Point (continued)
Lubrication Point
11 FELT, D3.6 for COMBINATION GEAR
12, 22.4 (set the felt to Shaft B)
• Lubricate the inner all part of the
Combination Gear, 12,22.4 with O-12 by
brush.
• Dip the felt in the oil to soak it
• Insert the Felt, D3.6 with O-12 to Shaft B.
NOTE:1) Do not use Felt with white
core.
2) Do not spill on Lever Planet
Unit during insertion of Felt.
3) Do not hang down oil to any
part except on the shaft.
12 FELT, D3.6 for COMBINATION GEAR
14, 28 (set the felt to Shaft A)
• Lubricate the inner all part of the
Combination Gear, 14,28 with O-12 by
brush.
• Dip the felt in the oil to soak it
• Insert the Felt, D3.6 with O-12 to Shaft A.
NOTE:1) Do not use Felt with white
core.
2) Do not spill on Lever Planet
Unit during insertion of Felt.
3) Do not hang down oil to any
part except on the shaft.
13 Groove on "ROLLER, PF"
• Apply the grease to the groove on the
Roller PF.
14 Contact area for ROLLER, EJECT and
GROUND SPRING, EJECT
• Apply the grease while rotating the shaft.
Revision C
Lubricant Type &
Refer to:
Amount
O-12 Page 161
Soak in.
O-12 Page 161
Soak in.
G-26 Page 162
φ
1 x 5mm
G-26 Page 162
φ
1 x 2mm
157