Chapter 6
Figure 6-4. Installing the Accessory Board
12. Secure the PCI board as shown in Figure 6-4.
13. If the installed accessory board requires an external connection or a
connection to the System board, ensure the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
14. If accessory board installation is complete, re-install the cover on the
NetServer.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
15. Re-install the bezel onto the front of the HP NetServer.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
1. Insert Board
2. Close Latch
Installing Additional Boards
3. Turn Tab
69