Operator display
The operator display is located on the front door of the MCS unit.
The following tools are required for installation:
•
8-mm socket
•
Small Flathead screwdriver
Removing the operator display
Power down the MCS unit
1.
Open the front MCS door.
2.
Using an 8 mm socket or wrench, remove the three nuts and external star washers securing the
3.
operator display rear cover to the back of the front MCS door.
Remove the operator display rear cover.
4.
("Powering down the MCS
unit" on page 24).
Removal and replacement procedures 88