Using a T-25 Torx driver, secure the horizontal shipping bracket to the MCS unit by inserting four
4.
Torx screws.
Condensation pump and sensors
The condensation pump and sensors are components of the water group located at the bottom interior of
the MCS unit.
The following tools are required for installation:
•
T-25 Torx driver
•
Phillips screwdriver
Removing the condensation pump and sensors
Power down the MCS unit
1.
Remove the bottom fan unit
2.
Relocate the power inlet box
3.
Remove the air sealing plate
4.
("Powering down the MCS
("Removing the bottom fan
("Relocating the power inlet
("Removing the air sealing
unit" on page 24).
unit" on page 44).
box" on page 93).
plate" on page 35).
Removal and replacement procedures 47