Divar 700 Series
4.6
Monitor connections
On the hybrid version up to two monitors can be connected through the VGA, CVBS, or Y/C
connections. A single monitor can be connected on the network version.
4.6.1
VGA
Connect the unit to the monitor using standard VGA cable.
Note:
It is recommended to use 17-inch or larger LCD monitors.
Specifications
Output signal: VGA
Resolution: 1280 x 1024 (monitor A), 1024 X 768 (monitor B)
Color: True color (32 bit)
Connector type: DE-15
Figure 4.8 VGA monitor connectors (hybrid version)
4.6.2
CVBS
Connect the unit to CCTV monitors using 75 ohm video coaxial cables with BNC connectors.
The unit provides a 1 Vpp CVBS signal.
If the monitor has a loop-through connection without using the loop-through output, then
select the 75 ohm impedance setting on the monitor. If the monitor's loop-through output is
connected to an additional device, the device's termination is set to 75 ohm and the monitor's
termination is set to high impedance. (This is not necessary on devices with automatic
termination.)
Specifications
Output signal: Composite video 1Vpp, 75 ohm, Sync. 0.3Vpp ±10%
Resolution: 720 x 576 PAL, 720 X 484 NTSC
Connector type: BNC
CVBS
Figure 4.9 CVBS monitor connectors (hybrid version)
4.6.3
Y/C
Connect the unit to a CCTV monitor with Y/C input, using a standard Y/C connection cable.
Y/C
Figure 4.10 Y/C monitor connectors (hybrid version)
Bosch Security Systems
B
A
VGA
B
A
B
A
Installation and Operation manual
Hardware setup | en
F.01U.140.955 | v3.0 | 2009.11
27