Eternus Web Gui Startup - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 5 General Settings
5.3

ETERNUS Web GUI Startup

2
After approximately two minutes (after approximately six minutes in a Unified configuration), check
that the READY LED ( ) of the controller enclosure is lit up.
When checking the connection between the PC terminal and the ETERNUS DX Disk storage system, exe-
cute the "ping" command at the PC command prompt. An example of ping execution is shown below.
("192.168.1.1" is the default IP address for the ETERNUS DX Disk storage system)
ping 192.168.1.1
If the execution results in an error, check the network settings of the PC terminal.
When communication cannot be secured even after the RMT port of Controller 0 (CM#0) is connected
to the LAN port of the PC terminal, make sure that the MASTER LED of Controller 0 (CM#0) is turned
on. When two controllers are installed and the MASTER LED of Controller 1 (CM#1) is turned on, use
the RMT port of Controller 1 (CM#1).
5.3 ETERNUS Web GUI Startup
Start up ETERNUS Web GUI via the Web browser of the connected terminal.
If the settings of the Web browser are incorrect, ETERNUS Web GUI may not be connected. For details on
these settings, refer to "Configuration Guide (Web GUI)".
1
Open the Web browser on the terminal.
2
Enter the following URL in the address bar of the Web browser:
http://192.168.1.1/
The login screen for ETERNUS Web GUI appears.
3
To change the language, click the [Option] button and select [English] or [Japanese] in [Language].
4
Enter the User ID and Password.
User ID: root
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Drive enclosure
Controller enclosure
76
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0