Advertisement
Powering up the DFL-1000
Connect the power cord to the DFL-1000 and plug it in. The Power
indicator on the front panel will light up and then the Status light will begin
flashing, indicating that startup has begun. After about 45 to 60 seconds
the DFL-1000 will be ready for use.
Configuring the DFL-1000
There are two ways to configure the network interface addresses of the
DFL-1000.
1. Using Microsoft Internet Explorer © web interface:
•
Set the IP address of your management computer to 192.168.1.2 with netmask
255.255.255.0
•
Connect the management computer to the Internal interface of the DFL-1000
through an crossover ethernet cable or network hub
•
In the Internet Explorer Address Bar enter https://192.168.1.99
•
Enter "admin" for the user name, leave the password blank and click OK
•
Click on System and then on Network. Addresses can be viewed and set on
the IP Address page.
•
Once the addresses are set you are ready to connect the DFL-1000 to your
network. Section 6 below will guide you through this process.
2. Using command line interface:
•
Connect one end of the null-modem serial cable to the Console connector at
the front of the DFL-1000 and connect the other end to the serial port of an
administration computer or terminal.
•
Start a terminal program, for example the HyperTerminal included with the Win-
Advertisement
