D-Link DAP-2565 AirPremier Quick Install Manual
N dual band poe access point
Hide thumbs
Also See for DAP-2565 AirPremier:
- Brochure & specs (4 pages) ,
- Quick install manual (13 pages)
Related Manuals for D-Link DAP-2565 AirPremier
Summary of Contents for D-Link DAP-2565 AirPremier
- Page 1 Quick Install Guide DAP-2565 ® Dual Band PoE Access Point B u s i n e s s C l a s s N e t w o r k i n g...
-
Page 2: System Requirements
After one year, the service requires an annual subscription. Package Contents If any of following items are missing, please contact your reseller: • D-Link DAP-2565 AirPremier N Access Point powered by CloudCommand™ • Power Adapter • Power Cord •... - Page 3 Welcome to D-Link’s line of cloud-managed wireless Access Points. Leverage the product’s online interface to configure, deploy, secure and manage your entire wireless network. Registering Your Access Point Online Step 1: Before you can use the Access Point, you must register it online.
- Page 4 Option 1: Deploying Your Access Point with Dynamic IP Addressing If your network automatically assigns IP addresses ( DHCP service ), connect the Access Point directly to the network by plugging an Ethernet cable into the LAN port on its rear panel. Insert the cable’s other end into your existing switch or router with Internet connectivity.
- Page 5 Option 2: Deploying Your Access Point without Dynamic IP Addressing If your network does not automatically assign IP addresses ( No DHCP service ), follow these steps to properly configure your Access Point: Configure APs Step 1: Connect the Access Point directly to your computer using an Ethernet cable.
- Page 6 Step 3: Launch a web browser and type either the IP address of the access point (default - 192.168.0.50) or the default device name of the access point (http://dlinkapxxxx where xxxx are the last 4 numbers of the MAC address). The MAC Address is on the lower-left corner of the device label (highlighted below).
- Page 7 Step 5: Once logged in, you will be able to change the Access Point’s IP address and DNS information to match your existing network configuration. Step 6: No additional configuration is required. Within a few minutes the Access Point will self configure and become ready to use. You have the option of later reconfiguring your Access Point to a new static IP address using the CloudCommand™...
- Page 8 CloudCommand™ Dashboard To view your CloudCommand™ dashboard, please log in at http://dlink.cloudcommand.com. The dashboard is your starting point to monitor network activity, troubleshoot problems, authorize and disconnect individual devices, or make configuration changes to your Access Point(s). Manage Access Points and connected View devices connected to your devices primary wireless network...
- Page 9 Notes...
- Page 10 Notes...
- Page 11 Notes...
-
Page 12: Technical Support
Copyright ©2011 D-Link Corporation/D-Link Systems, Inc. All rights reserved. D-Link and the D-Link logo are registered trademarks of D-Link Corporation or its subsidiaries in the United States and other countries. CloudCommand™ is a trademark of PowerCloud™ Systems, Inc. All rights reserved.