4.
Press the release tab as shown in the following illustration (1).
Figure 4-63
5.
Slide the system board toward the front of the chassis and then lift it out of the workstation (2).
Installing the system board
To install the system board:
1.
Set the system board in the chassis, slightly away from the rear of the chassis. The mounting hooks
will seat in the recesses of the tray so that the tray lies flat on the chassis base.
2.
Slide the tray towards the rear of the chassis until the heat sink mounting holes are aligned.
3.
Reinstall the processor heatsink, cards, and cables.
Product recycling
The Planet Partners recycling service provides an easy way to recycle computer equipment,
rechargeable batteries, or HP printing supplies. HP processes ensure that unwanted hardware or empty
HP printing supplies are recycled responsibly.
For information about recycling HP components or products, visit http://www.hp.com/go/recycle.
108 Chapter 4 Removal and replacement procedures
Removing the system board
ENWW