SAS hard drive
This section describes how to remove and install a SAS hard drive.
Removing a SAS hard drive
1.
Disconnect power from the system
the side access panel
2.
Disconnect the power (1) and data (2) cables from the hard drive.
Figure 4-47
3.
Lift the green drive-lock release tab (1), and then slide the hard drive out of the chassis (2).
Figure 4-48
96
Chapter 4 Removal and replacement procedures
(Predisassembly procedures on page
(Removing the side access panel on page
Disconnecting the SAS hard drive cables
Removing the SAS hard drive
58), and then remove
64).
ENWW