Yamaha POCKETRAK W24 Reference Manual page 84

When the unit is connected to the computer, the unit does not display the
"Connected" icon.
Possible cause
Corrective action
The recorded audio sounds noisy.
Possible cause
Corrective action
Possible cause
Corrective action
The recorded sound is distorted.
Possible cause
Corrective action
The recorded sound skips.
Possible cause
Corrective action
Possible cause
Corrective action
POCKETRAK W24 Reference Manual
The unit is not connected to the computer correctly.
In some cases, the unit may not display the "Connected" icon or may not
be recognized when it is connected to a computer. Disconnect the unit
from the computer, then reconnect it.
Wind noise has been recorded.
The built-in stereo microphone is highly sensitive. Therefore, a slight
breeze or breath — even a weak air conditioning breeze that hits the
microphones directly — will be recorded as noise. To reduce the level of
wind and other environmental noise:
• Use the recorder with the wind screen (protection against wind and
sibilance) attached to the built-in stereo microphones.
• Turn on the High Pass Filter via menu item [HPF] (see
• Set the [MIC SENS] (microphone sensitivity) switch to [LOW].
The battery is exhausted.
Replace the battery.
The microphone sensitivity level may not be appropriately set.
• Set the [MIC SENS] (microphone sensitivity) switch to [LOW]. If you still
hear distortion, set the High Pass Filter to ON and attach the
windscreen to the recorder (see
• If the ALC function is turned off, set the recording peak limiter to ON
(see page 21).
• The microSD card was formatted not on the recorder, but on a
computer or other device.
• The microSD card may be fragmented significantly.
Use the recorder to format the microSD card (see
You are using a microSD card that is not recommended by Yamaha.
Use a microSD card that is recommended by Yamaha (refer to the Owner's
Manual).
page 21).
page
15
Appendix
page 21).
53).
84