Sony ACY-RK2 Operating Instructions Manual page 13

1
Loosen the screws on both sides of the front panel.
Loosen each A cap so that it protrudes by about 5
mm.
2
To remove the front panel, check that the screws on
both sides are loose, then pull the front panel
horizontally in the direction of the arrows.
3
Remove the A caps and replace them with the B
caps.
Removing the A Caps
While pressing the A cap inward with your finger,
use the Allen wrench to loosen the set screw and
remove it.
A cap
Allen wrench
Installing the B Caps
Insert a set screw into the B cap, then align the B
cap with the pin in notch D on the front panel and
insert the B cap into notch D. After confirming that
notch D and the set screw are properly aligned, use
the Allen wrench to tighten the set screw while
pressing the B cap inward with your finger.
A cap
4
Return the front panel to its original position.
Mounting the L-shaped Brackets
1
Use a Philips screwdriver to remove the screws on
one side of the library.
2
Use two A screws to mount an L-shaped bracket on
the side of the library as shown in the diagram.
3
Mount the L-shaped bracket on the other side of the
library in the same manner.
notch D
B cap
Set screw
The flat side of
the pin is referred
to as notch D.
13
Preparation