Performing The Initial Configuration - Nokia IP200 Series Installation Manual

4. Check the power LED (the Nokia logo) on the front panel of the appliance

Performing the Initial Configuration

The initial configuration allows you to assign a hostname, create the admin
password, and to configure the management interface.
To perform the initial configuration
1. Turn on the appliance.
Nokia IP200 Series Security Platform Installation Guide
Note
The IP200 appliance power supply automatically detects the input
voltage (115 VAC or 220 VAC [100 to 127 and 200 to 240]) and
configures itself appropriately.
to ensure that the power supply is operating correctly.
If the fans are not running, or if the power LED is not illuminated, make
sure that:
The power cord is properly connected.
The power supply switch is on.
Power is turned on to the power strip or wall receptacle into which you
plugged the appliance.
If the fans are still not running, or if the power LED does not illuminate,
contact your Nokia service provider as listed in
Information" on page 3 for technical support.
At the console a series of startup messages appears, then the following
prompt appears:
Type any character to enter command mode.
The prompt remains on the screen for about five seconds. If you type any
character during this time, the system activates the Nokia IPSO boot
manager.
Performing the Initial Configuration
"Nokia Contact
43