Installing The Battery; Hard Disk Drive; Removing The Hard Disk Drive - HP Z400 Maintenance And Service Manual

5.
Pull the tab (1) on the battery holder, and then lift it straight up (2), as shown in the following
figure.
Figure 5-53

Installing the battery

To install the battery:
1.
Confirm the polarity (positive or negative) of the battery to position it correctly in the battery
holder.
2.
Place the battery edge under the plastic housing tab and press gently until it snaps into place.

Hard disk drive

This section provides information to successfully remove and install a hard disk drive.

Removing the hard disk drive

To remove a hard disk drive:
1. Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4. Disconnect the power and data cables from the drive.
ENWW
Removing the battery
Predisassembly procedures on page
Removing the side access panel on page
Predisassembly procedures on page
Removing and installing components
75).
75).
78).
129