Removing A Dimm - HP Z400 Maintenance And Service Manual

Removing a DIMM

To remove a DIMM:
1. Power down the workstation (see
2.
Disconnect power from the workstation (see
CAUTION:
the workstation and unplug the power cord from the AC power outlet. Otherwise, the workstation
may not recognize the memory changes.
3. Remove the side access panel (see
4.
If your system has an airflow guide, remove it (see
5. Push gently outward on the DIMM socket levers (1) as shown in the following figure.
Figure 5-45
6.
Lift the DIMM straight up (2) and out of the socket, then store the DIMM in an antistatic bag.
118 Chapter 5 Replacing components
Predisassembly procedures on page
To prevent electrical damage to the DIMMs during removal or installation, power off
Removing the side access panel on page
Removing a DIMM
Predisassembly procedures on page
Removing the airflow guide on page
75).
75).
78).
110).
ENWW