Loading Bottom Rack - Kenmore 665.1372 Use & Care Manual

To adjust the top rack
1. Hold the top rack with one hand near the adjuster.
2. With the other hand, pull out the top of the adjuster.
3. Raise or lower the rack to one of the preset positions.
4. Release the adjuster.
5. Repeat the steps for the remaining adjusters.
NOTE: The top rack must be level.
Removable top rack
The removable top rack allows you to wash larger items
such as stock pots, roasters, and cookie sheets in the
bottom rack.
IMPORTANT: Remove dishes prior to removing the rack
from the dishwasher.
To remove the top rack
1. Pull the rack forward slightly to access clips.
2. While pressing the ridges in, push back on the clip until
the outer side releases. Slide the clip to the inside of
the track edge to remove the clip.
3. After removing both clips, pull rack out.
To replace the top rack
1. Place the rollers on each side of the rack into the rack
tracks and push the rack back.
2. Align the open side of the clip with the inside edge of
the rack track.
3. Push the ridges and slide the clip toward the outside
rack edge until it locks into place.
4. Repeat on the other side.
5. Pull the rack out all of the way to ensure clips are fully
seated.
10
Flexible tines (on some models)
The row of tines on the left-hand and right-hand sides of
the top rack can be adjusted to make room for a variety of
dishes.
To adjust the flexible tines
1. Grasp the tip of the tine that is in the tine holder.
2. Gently push the tine out of the holder.
3. Lay the tines down, toward the center of the rack.
No-flip clips (on some models)
The no-flip clips hold lightweight plastic items such as
cups, lids, or bowls in place during washing.
To move a clip
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.

Loading Bottom Rack

The bottom rack is designed for plates, pans, casseroles,
and utensils. Many items, up to 13" (33 cm) tall, fit in the
bottom rack. (See recommended loading patterns shown.)
NOTE: The features on your dishwasher rack may vary
from the drawings shown.
10 place setting
Do not load glasses, cups, or lightweight plastic items
■
in the bottom rack. Load small items in the bottom rack
only if they are secured in place.
Load plates, soup bowls, etc., between tines.
■
Overlap the edges of plates for large loads.
■