Table of Contents
Advertisement
7.2.1.6
This tests sending and receiving data for the local console port (UART1) and target
port (UART2) using a loop back cable. Port settings of 460800bps and 8N1 are used
to perform the test.
Sent data is received from the loop back cable so the test is performed at that point
and ends at any point an inconsistency is discovered.
When set to "continuous", the test ends at any point a key is pressed.
When sent data size is specified, the test ends when the specified amount of data is
sent and received.
UART test
---------------------
1: data compare test
2: bus integrity test
3: return
select >
7.2.1.6.1
7
Data from 0x00 to 0xFF is repeatedly sent.
(1) Input format
Specify the port to test, whether to test continuously, and the sent data size if not
testing continuously.
Local Console? [Y/N, N:Target Port] > N
continuous? [Y/N] > N
How many size? (kB) [-1:100kB] > 300
connect Loop back cable. then hit any key
connect terminal from Target Port for message output.
if ready, hit any key from Target Port
When testing the local console port, the target port is used for a terminal to input and
output messages so connect a terminal to the target port. After connecting the loop
back cable to the local console, press any key on the target port terminal.
When connecting a terminal to a target port, attach a type A adapter to the cable and
connect it to a PC.
(2) Operating the terminal and test results
Follow the steps below to display the test results.
(a) Specify the target port and size
Local Console? [Y/N, N:Target Port] > N
continuous? [Y/N] > N
How many size? (kB) [-1:100kB] > 300
connect Loop back cable. then hit any key
running [100%]
complete!
hit any key
SERVIS IP-Serial
176
1p Converter
User's Guide
UART test
data compare test
Enter
Enter
Enter
Enter
Enter
Enter
<- Updates the percentage display as needed
Advertisement
Table of Contents
