Operation And Important Riding Points; Starting And Warming Up A Cold Engine - Yamaha VMAX VMX12V Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

WARNING
G
Become thoroughly
1
with all operating controls and
their functions before riding.
2
Consult a Yamaha dealer re-
garding any control or function
3
that you do not thoroughly un-
derstand.
G
Never start the engine or oper-
4
ate it in a closed area for any
length of time. Exhaust fumes
5
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
6
short time. Always make sure
that there is adequate ventila-
7
tion.
G
Before starting out, make sure
8
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
9
ground and distract the opera-
tor, resulting in a possible loss
of control.
EAU15950
Starting and warming up a
cold engine
EWA10270
In order for the ignition circuit cut-off
familiar
system to enable starting, one of the
following conditions must be met:
G The transmission is in the neutral
position.
G
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
WARNING
G Before starting
check the function of the igni-
tion circuit cut-off system ac-
cording
described on page 3-15.
G
Never ride with the sidestand
down.
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to "RUN".
CAUTION:
If the fuel level warning light comes
on, check the fuel level, and, if nec-
essary, refuel as soon as possible.
EAU32300
NOTE:
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical cir-
cuit.
EWA10290
the engine,
NOTE:
If the engine fails to start, release the
to the procedure
start switch, wait a few seconds, and
then try again. Each starting attempt
should be as short as possible to pre-
serve the battery. Do not crank the en-
gine more than 10 seconds on any one
attempt.
ECA10220
5-1
2. Shift the transmission into the neu-
tral position.
3. Turn the starter (choke) on and
completely close the throttle. (See
page 3-8.)
4. Start the engine by pushing the
start switch.
CAUTION:
G
The oil level warning light and
fuel level warning light should
come on when the start switch
is pushed, and they should go
ECA10230