Color Video Camera Instruction Manual Models: LD300N-B/C/D/E/F LD300P-B/C/D/E/F Before installing, operating or adjusting this product, please read this instruction booklet carefully and completely.
Page 2
REGULATORY INFORMATION: FCC CAUTION Part 15 RISK OF ELECTRIC SHOCK This equipment has been tested and found DO NOT OPEN to comply with the limits for a Class A CAUTION: TO REDUCE THE RISK OF digital device, pursuant to Part 15 of the ELECTRIC SHOCK FCC Rules.
Page 3
This product is manufactured purchased the product. to comply with EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC. European representative : LG Electronics Service Europe B.V. Veluwezoom 15, 1327 AE Almere, The Netherlands (Tel : +31-036-547-8940)
Important Safety Instructions Read these instructions. they exit from the apparatus. Keep these instructions. 11. Only use attachments/acces- Heed all warnings. sories specified by the manufac- Follow all instructions. turer. Do not use this apparatus near 12. Use only the cart, stand, tripod, water.
Safety Precautions Do not attempt to disassem- Avoid the camera with direct ble the camera sunlight To prevent electric shock, do not remove Do not aim the camera at bright objects. screws or covers. There are no user Never face it with direct sunlight or other serviceable parts inside.
Installation Camera Installation 1. Aim the LG logo of the Dome Camera to face the place that you wish to watch. 2. Tighten the M4 Tapping Screws to fix the Dome Camera on the ceiling, then adjust the Pan (Left / Right) by moving the Pan Base. Tighten the M4 Tapping Screws after adjustment.
Installation Camera Connection Connect the Power Adapter (DC 12V, 300mA; optional) to the Power Input Jack of the camera as shown below. Power Adapter Power Input Adapter (Not supplied) Jack Jack Monitor...
Page 10
Installation Notes: • When you disassemble the Dome Cover, lift the Dome Cover Separatory Spring on the opposite side of LG Logo and turn the Dome Cover clockwise simultaneously. Dome Cover Separatory Spring • When you install the camera, handle with care. The camera could be damaged by improper handling or storage.
Page 11
Setup 6-pin Dip Switch Setting 2. FL (Flickerless) Use for removing the flicker of picture. This camera has the 6-pin Dip The default setting is OFF. Switch for setting. 3. AWB/HOLD AWB (Auto White Balance), HOLD (White Balance Hold). The default setting is AWB. 4.
Troubleshooting Check the following guide for the Contrast of the screen is not possible cause of a problem before clear. contacting service. Check the condition of the monitor. A light source such as a spot light causes burn-in on the display The picture is poor screen.