Download Print this page
Pioneer S-STP600 Operating Instructions
Pioneer S-STP600 Operating Instructions

Pioneer S-STP600 Operating Instructions

Speaker system

Advertisement

Quick Links

S-STP600
What's in the box
Check that you have all the supplied accessories before you start:
• Front speakers x 2
• Center speaker x 1
• Surround speakers x 2 / Surround back speaker x 1
• Speaker cords x 1
• Non-skid pads
• Brackets for wall mounting x 5
• Screws x 5
• These operating instructions

Before you start

Thank you for buying this Pioneer product.
Please read through these operating instructions before installing
and using your speaker system.
Important
In order to prevent damage to the speaker system resulting from
input overload, please observe the following precautions:
• Do not supply signal to the speaker system in excess of the
maximum permissible input.
• When connecting or disconnecting cables, make sure that your
amplifier is switched off.
• Do not use excessive amplifier volume if using a tone control to
emphasize high or low frequencies.
Caution
• Do not connect the supplied speakers to any amplifier other
than the one supplied with this system. Connection to any other
smplifier may result in malfunction or fire.
• Pioneer will not be responsible for any accidents or damage that
may result from improper installation.

OPERATING INSTRUCTIONS

Making receiver settings
Before connecting the speakers, please read the Operating
Instructions supplied with your VSX-515 or VSX-815 receiver to make
the following settings:
• Switch the speaker impedance to the 6Ω setting (see Switching
the speaker impedance to do this).
• Set the crossover frequency to 200Hz (see Crossover network to
do this).
After connecting the speakers, please complete Using the Quick
Setup with the 6.1ch setting (refer to the receiver's 5 minute guide in
the supplied Operating Instructions).

Connecting the speakers

To get the best out of your speakers it is important that you connect
them properly to your amplifier or receiver. Each speaker
connection consists of a positive (+) and a negative (–) terminal.
These should be matched between the amplifier and the speaker.
Important
• Make sure all equipment is turned off before making any
connections.
1
Twist and pull off the protective shields on each speaker
wire.
2
Attach one end of the supplied speaker cord to the rear of
the center speaker.
Connect the wire with the colored marker to the red (+) terminal; the
plain wire to the black (–) terminal. Press down the spring-loaded
tab and insert the wire, as shown below. Release the tab to secure
the wire.
Red (+)
Black (–)
www.pioneerelectronics.com
SPEAKER SYSTEM
Green colored
marker

Advertisement

loading

Summary of Contents for Pioneer S-STP600

  • Page 1: Operating Instructions

    • Do not connect the supplied speakers to any amplifier other than the one supplied with this system. Connection to any other smplifier may result in malfunction or fire. • Pioneer will not be responsible for any accidents or damage that may result from improper installation.
  • Page 2: Placing The Speakers

    Connect the other end of each speaker cable to your receiver. Placing the speakers The speaker cables are color-coded for your convenience. Make sure The diagram below shows the standard speaker placement relative to match the speaker cable with the proper terminal (as indicated on to your listening position.
  • Page 3: Troubleshooting

    • If you are unsure of the qualities and strength of the walls, Note: Specifications and design subject to possible modification consult a professional for advice. without notice due to improvements. • Pioneer is not responsible for any accidents or damage that result from improper installation. Bracket screw (supplied)
  • Page 4 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555 PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia, TEL: (03) 9586-6300 PIONEER ELECTRONICS DE MEXICO S.A. DE C.V. Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico,D.F. 11000 TEL: 55-9178-4270 K002_A_En <05G000001>...