Installation; Accessories; Remote Control Battery Installation - Panasonic TU-PTA500U Operating Instructions Manual

Controller / tuner
Hide thumbs Also See for TU-PTA500U:
Table of Contents

Advertisement

Installation

ACCESSORIES

Check the accessories before installations.
Operating
Instruction book
TQBC0216

Remote control battery installation

Requires two AA batteries.
1. Turn the transmitter face down.
Remove top cover by pressing
down on marking and sliding
cover off in the direction
indicated.
Helpful Hint:
For frequent remote control users,
replace old battery with Alkaline
batteries for longer life.
Note: In order to maximize the life of
the batteries, the lighted buttons on
the Remote Control can be turned
OFF and ON by pressing R-TUNE
and RECALL at the same time.
Helpful Hint:
Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend
that you record the code on page 54 – 57, prior to setting up the remote.
6
Remote Control
Transmitter
EUR511164
LIGHT
POWER
ASPECT
MUTE
TV/VIDEO
CH
VOL
ACTION
VOL
MENU
INFO/RECALL
CH
SURROUND
NORMAL
OFF TIMER
PC
EXIT
VCR REC
GUIDE
REW
STOP
PLAY
FF
TV/VCR
VCR/DBS
CHANNEL
PAUSE
OPEN/CLOSE
SLOW
STILL
1
2
3
4
5
6
7
8
9
R-TUNE
PROG
0
2. Install the batteries as shown in
the battery compartment.
(Polarity + or – must match the
markings in the compartment).
Two AA size
Incorrect installation can cause battery leakage and corrosion that will
damage the remote control transmitter.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn
5. Battery replacement is necessary when remote control acts
Battery for the Remote
Display Cable
Control Transmitter
K1HA26FA0001
(2 AA (IEC R6) size)
Precaution on battery use
batteries when replacing the old set.
used batteries.
sporadically or stops operating this unit.
Warranty Card
Ferrite Core
TSK1027
3. Replace the cover and slide in
reverse until the lock snaps.

Advertisement

Table of Contents
loading

Table of Contents