Table of Contents
Advertisement
Installation
8 Before starting with the installation, connect the antenna, speaker and
head unit, then check your DAB receiving condition.
8 Disconnect the cable from the negative (–) battery terminal (see cau-
tion below).
Caution: Do not disconnect the battery terminals of a car with a trip or navigational computer since all
user settings stored in memory will be lost. Instead take extra care with installing the unit to prevent
shorts.
Installation Precautions
This product should be installed by a professional installer, if possible.
In case of difficulty, please consult your nearest authorized Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery system (car) with negative ground.
2. Follow the electrical connections carefully (aPage 34, 35). Failure to do so may result in damage to the
unit.
3. Connect the power lead after all other connections are made.
4. Be sure to connect the battery lead (yellow) to the positive terminal (+) of the battery or fuse block (BAT)
terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions of the respective equipment before con-
necting it to this unit.
Supplied Hardware
No.
Item
q
Power Connector
w
DIN Cord (5 m)
e
Velcro Tape
Tapping Screw with
r
Washers
(ø5 mm x 16 mm)
Preparations
Diagram
Q'ty
No.
t
1
1
y
u
2
i
4
o
Item
Antenna
(Antenna Cord 6 m)
Cleaning Kit
Cord Clamp
Hexagonal Wrench
Watertight Rubber
CY-DAB2000N
E
N
G
L
I
S
H
26
Diagram
Q'ty
1
1
5
1
1
29
Advertisement
Table of Contents
