Advanced Log Settings - D-Link DFL-260E User Manual

2.2.7. Advanced Log Settings

Web Interface
1. Go to Log & Event Receivers > Add > SNMP2cEventReceiver
2. Specify a name for the event receiver, for example my_snmp
3. Enter 195.11.22.55 as the IP Address
4. Enter an SNMP Community String if needed by the trap receiver
5. Click OK
The system will now be sending SNMP traps for all events with a severity greater than or equal to Alert to an
SNMP trap receiver at 195.11.22.55.
2.2.7. Advanced Log Settings
The following advanced settings for NetDefendOS event logging are available to the administrator:
Send Limit
This setting specifies the maximum log messages that NetDefendOS will send per second. This
value should never be set too low as this may result in important events not being logged, nor should
it be set too high. When the maximum is exceeded, the excess messages are dropped and are not
buffered.
The administrator must make a case by case judgement about the message load that log servers can
deal with. This can often depend on the server hardware platform being used and if the resources of
the platform are being shared with other tasks.
Default: 2000
Alarm Repetition Interval
The delay in seconds between alarms when a continuous alarm is used. Minimum 0, Maximum
10,000.
Default: 60 (one minute)
Chapter 2. Management and Maintenance
61