Related Manuals for Bosch DKE 985 C
Summary of Contents for Bosch DKE 985 C
- Page 1 DKE 985 C Operating and installation instructions Internet: http://www.bosch-hausgeraete.de Bosch Info-Team: de Tel. 01 80/5 30 40 50 (E 0,14/Min. DTAG)
- Page 2 Fig. 1 Abb. 1 ELECTRO mind. mind.
-
Page 3: Appliance Description
Instructions for use: Appliance description Operating modes This can be achieved if combustion air can Chimney flow through non-lockable openings, e.g. in panelling doors, windows and via the air- intake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. -
Page 4: Before Using For The First Time
Before using for the first time Important notes: Before using your appliance for the first The Instructions for Use apply to several time, please read these Instructions for versions of this appliance. Accordingly, Use carefully. They contain important you may find descriptions of individual information concerning your personal features that do not apply to your safety as well as on use and care of the... -
Page 5: Operating Procedure
Operating procedure Intensive setting: The most effective method of removing vapours produced during cooking is to: Maximum power is obtained at the intensive setting. It is only required for short Switch the ventilator ON intervals. as soon as you begin cooking. Keep pressing the + button until a ç... -
Page 6: Filters And Maintenance
Filters and maintenance Grease filters: Removing and inserting the metal grease filters: Metal filters are used to trap the greasy Warning: The halogen bulbs must be element of the vapours that develop switched off and cool. during cooking. 1. Press the catch on the grease filters The filter mats are made from non- inwards and fold the filters down. - Page 7 Filters and maintenance Activated carbon filter: Saturation indicator: ã For neutralizing odours in recirculating When the activated carbon filter reaches mode. saturation point, an acoustic signal is Caution: sounded for 6 seconds after the fan has switched off, and a appears in the As the filter becomes more and more ã...
-
Page 8: Cleaning And Care
Cleaning and care Replacing the light bulbs Isolate the extractor hood by pulling out 1. Switch off the extractor hood and pull the mains plug or switching off the fuse. out the mains plug or switch off the electricity supply at the fuse box. Do not clean the extractor hood with abrasive sponges or with cleaning agents When switched on, the halogen bulbs... -
Page 9: If You Encounter A Problem
Setting the saturation indicator If you encounter a problem If an appears in the display: If it becomes necessary to change the ã operating mode (exhaust-air/recirculating See "Filters and maintenance" Section. mode), the saturation indicator for the filters If is not possible to operate the extractor must also be altered (see Installation hood: Instructions). -
Page 10: Installation Instructions
Installation Instructions: Important information Additional information concerning gas Old appliances are not worthless cookers: rubbish. Valuable raw materials can be reclaimed by recycling old appliances. When installing gas hotplates, comply Before disposing of your old appliance, with the relevant national statutory render it unusable. -
Page 11: Prior To Installation
Prior to installation Exhaust-air mode mind.40 mind. 45 700-1105 mind.550 The exhaust air is discharged upwards This can be achieved if combustion air can through a ventilation shaft or directly flow through non-lockable openings, e.g. in through the outside wall into the open. doors, windows and via the air- intake/exhaust-air wall box or by other Exhaust air should neither be directed... - Page 12 Prior to installation For optimum extractor hood efficiency: Connecting a l 150 mm exhaust-air pipe: Short, smooth air exhaust pipe. Mount the pipe As few bends in the pipe as possible. directly onto the Diameter of pipe to be as large as air outlet on the possible and no tight bends in pipe.
-
Page 13: Electrical Connection
Prior to installation Electrical connection If you fit your own plug, the colours of Preparing the wall these wires may not correspond with the The wall must be flat and perpendicular. identifying marks on the plug terminals. Ensure that the wall is capable of This is what you have to do: providing a firm hold for mounting 1. -
Page 14: Installation
Installation This extractor hood is intended to be Note: Take into account any special mounted onto the kitchen wall. accessories that are going to be fitted. 1. Remove the grease filter (refer to 5. Attach the fixing bracket for the Operating Instructions). - Page 15 Installation 08. Screw in the two lower hexagon head 13. Push both sections of the flue panelling cap screws. together (slots in the upper section must be pointing downwards) and Before the 4 screws are tightened insert into the opening in the extractor down, align the extractor hood properly.
- Page 16 DHZ 5165 351210 9000 235 989 Robert Bosch Hausgeräte GmbH Printed in Germany 0407 Es.