Internet Security Router User's Manual
Filter Rule drop-
down list
9.7.1.5
Delete an Application Filter
To delete an Application Filter, click on the
1. Open the Application Filter Configuration page (see section 9.7.1.2Access Application Filter
Configuration Page – (Firewall è Policy List è Application Filter)).
2. Select the application filter to delete. Click on the
the Application Filter List table or select the filter type from the Filter Type drop-down list and then
select the filter rule from the Filter Rule drop-down.
3. Click on the
9.7.2
Configuring IP Pool
9.7.2.1
IP Pool Configuration Parameters
Table 9.8 describes the configuration parameters available for an IP pool.
Field
IP Pool Name
IP Pool Type
IP Range
Start IP
End IP
Subnet
Subnet Address
Subnet Mask
IP Address
Figure 9.24. Modify an Application Filter
icon of the filter to be deleted or follow the instruction below:
button to delete this filter.
Table 9.8. IP Pool Configuration Parameters
Description
Enter the name of the local IP
Select the type of IP Pool.
This option allows you to configure the range of IP addresses.
Enter the starting IP address of the range.
Enter the ending IP address of the range.
This option allows you to include all the computers that are connected in an
IP subnet.
Enter the appropriate IP address.
Enter the corresponding mask.
This option allows you to configure single IP address.
Chapter 9. Configuring Firewall/NAT Settings
Filter Type drop-down list
icon of the application filter to be deleted in
73