Chapter 3. Quick Start Guide
3.1.4
Step 4. Turn on the Internet Security Router, the ADSL or cable modem and
power up your computers.
Press the Power switch on the rear panel of the Internet Security Router to the ON position. Turn on your
ADSL or cable modem. Turn on and boot up your computer(s) and any LAN devices such as hubs or switches.
You should verify that the LEDs are illuminated as indicated in Table 3.1.
This LED:
POWER
LAN1 –
LAN4
WAN
10
Figure 3.1. Overview of Hardware Connections
Table 3.1. LED Indicators
...should be:
Solid green to indicate that the device is turned on. If this light
is not on, check if the power adapter is attached to the Internet
Security Router and if it is plugged into a power source.
Solid green to indicate that the device can communicate with
your LAN or flashing when the device is sending or receiving
data from your LAN computer.
Solid green to indicate that the device has successfully
established a connection with your ISP or flashing when the
device is sending or receiving data from the Internet.
Internet Security Router User's Manual