GE 164D4290P393 Owner's Manual And Installation Instructions page 14

FOR RECESSED-BOTTOM
11
CABINETS ONLY
Wood shims
• If the cabinets have front, side or back trim, make
2 wood shims the width of the trim and attach them
to the cabinet bottom recess on both sides. See Step
10 for marking locations.
12 CUT HOLES
Cut holes at marked locations for duct and electrical
wiring. For the vertical duct, cut out 3/4" extra
toward the front of the cabinet so you can move the
duct freely when installing the hood. It may also ease
installation by cutting the hole 10
13
RUN WIRES
Run the electrical wires through the wall or
cabinet according to National Electrical Code
and applicable local codes.
NOTE: DO NOT turn the power on until
installation is complete.
Installation Instructions
" instead of 10".
1 ⁄
2
14
14 SCREW IN PARTWAY
Drive a mounting screw (from the hardware packet)
partway into each center of the narrow neck of the
keyhole slots marked on the cabinet bottom.
OPTIONAL POWER CORD
15
KIT JXHC1
An optional Power Cord Connection Kit, model
JXHC1, is available at extra cost from your GE
supplier for installation using a standard 3-prong,
grounded wall outlet. Follow the Installation
Instructions packed with the kit to connect the
power cord to the range hood.
C
L
7 ⁄
3
4
NOTE: If using optional Power Cord Kit JXHC1,
feed the power cord through the hole in the top
cabinet while raising the hood. Loop any excess
length of cord and tie away with a suitable tape
or tie.
FEED IN WIRES
16
Lift the hood into position and feed the house
wiring through the wiring knockout.
Cabinet
3-prong
wall outlet
"
(if using cord
"
1 1 ⁄
connection)
4
" dia. clearance hole
1 3 ⁄
4
for optional power
supply location