Clear Pending Events; Busy Seconds (Line Busy) Reports - Bosch Conettix D6600 Installation And Operation Manual

Conettix D6600/D6100i | Installation and Operation Guide | 10.0 D6600/D6100i Operation

10.4.9 Clear Pending Events

Use this option to clear all pending events.
D6600
1.
F
FUNCTION
2. Enter password.
D6600 default password: 6600
D6100i default password: 6100
3. D6600 D6100
M/E
ENTER
D6600 D6100
4.
4
4
D6600 D6100
5.
Cancels the function and does
0
0
not delete all pending events.
D6600 D6100
1
Clears all pending events.
1
22
D6100
10.5

Busy Seconds (Line Busy) Reports

The D6600 software monitors and reports when a call
group of receiver lines cannot receive signals. The
receiver cannot process signals if its incoming
telephone lines are in trouble, if other communicators
have the line tied up, or if the line card is inoperative.
The receiver interprets these conditions as busy time.
The amount of busy time accumulated during a 10 min
period is the basis for a Busy Seconds Reports. The
10 min busy period begins when all lines in a call
group become busy, or when a non-programmed single
line for a call group becomes busy. The D6600/D6100i
totals the accumulated busy time and prints the Busy
Seconds Report after the 10 min period ends. After at
least 60 sec (10%) of busy time, the receiver generates a
report. The D6600/D6100i reports up to 100% busy
time.
Program the Busy Seconds Reports option to No if
Busy Seconds Reports are not wanted for all lines.
Setting the Line Sniff option to 2 disables reports for
individual lines.
Enable Seconds Reports for UL Listed
central stations.
UL inspectors might investigate the amount of time the
digital receiver lines cannot receive signals. Ensure
lines are available to process emergency signals on a
timely basis. Excessive Line Busy Reports can indicate
it is necessary to install additional lines in rotary with
your primary receiver lines.
Assign each line to a call group. For the group to start
accumulating busy time, all lines in the call group must
be online, in trouble, or without an operating line card.
Although it is not mandatory, not
assigning a line to a call group, or when
there is only one line in the group, 1 min
of busy time during a 10 min period
results in a Busy Seconds Report.
If you do not assign a line to a call group, displays and
printer reports identify the line number instead of the
Group number. A Line Busy Report shows and prints:
Bosch Security Systems, Inc. | 8/07 | 4998122704-02