Table of Contents
Advertisement
14
en | Installation
5
Installation
The PLE-SDT Plena Easy Line SD Tuner BGM source is designed for installation into a 19"
rack; however, it can also be used as a desktop unit. For 19" rack installation; use the 19" rack
mounting brackets which come with the source unit.
Figure 5.1 Set of 19" rack mounting brackets
5.1
Source unit connections / settings
1.
2.
CAUTION!
1.
2.
3.
4.
5.2
USB/SD
Connect a USB flash memory device to the USB socket (2 or 25). The use of USB HDD is not
recommended. And/or insert an SD/MMC memory card into the socket SD/MMC (15), the
notched corner of the card facing up as indicated on the unit's front panel.
5.3
Remote control
To insert the batteries (2x 1,5V, size AAA):
1.
2.
3.
NOTICE!
If the remote control is not in use for a longer period of time, remove the batteries to prevent
any damage due to battery leakage.
NOTICE!
Disposable batteries and battery packs at the end of their technical lives should be discarded
with due care for the environment. When possible, take batteries to a local recycling station.
PLE-SDT_OM | V1.0 | 2012.02
Connect any additional equipment/wires. Refer to Section 6 Connections.
Check/set the configuration settings. Refer to Section 7 Configuration.
Set the mains power switch (1) on the unit's front side to the Off position.
Make sure that the mains power selector (34) on the unit's rear side is correctly set for
the local mains voltage.
Change the mains fuse into T1.25A/250V, when connected to 115 V mains voltage.
Insert the power cord in the mains power inlet (33) and connect it into the distribution
network mains outlet.
Remove the battery compartment cover on the rear side of the remote control.
Insert the batteries as indicated in the battery compartment.
Close the battery compartment with the cover.
Installation and Operation manual
Plena Easy Line SD Tuner BGM source
Bosch Security Systems B.V.
Hide quick links:
Advertisement
Table of Contents
