Section 5: Setup; Main Menu - Honeywell HD6 Series User Manual

5.1

MAIN MENU

NOTE:
•
•
•
Upon power-up of an HD6, the scan displays an
initialization screen and counts down from 15 to 0.
The standard start-up message screen can be
turned ON or OFF from the main menu.
If the start-up screen message is ON, the following
screen is displayed.
Note: The protocol line displays the protocol set by
DIP switch S4.
If the start-up screen message is OFF, this screen is
displayed:
After the countdown, the scan accepts control
commands. Refer to the controller users' manuals
provided with your controller for operating
procedures.
Rev. 1.02
SECTION 5:
SETUP
Refer to Section 6 (operation) and
using Honeywell Diamond protocol.
Refer to Section 8 (operation) and
using Honeywell Maxpro mode, Honeywell VCL, Pelco P Code or
Pelco D Code control systems.
Refer to Section 10 (operation) and
using an American Dynamics control system.
Section 7 (programming) when
Section 9 (programming) when
Section 11 (programming) when
Protocol
9600 baud even parity – 8 bits
Camera
X
25
----UltraDome HD6----
Standard
FCB-EX48B
Honeywell Video Solutions
519543-1980
Please wait...15
Please wait...8
900.0679
22-June-2006