Bosch LTC 4600 Series Instruction Manual page 4

LTC 4600 Series | Instruction Manual | FCC & ICES Information
Your Bosch product was developed and
manufactured with high-quality material
and components that can be recycled and
reused. This symbol means that electronic
and electrical appliances, which have
reached the end of their working life,
must be collected and disposed of
separately from household waste
material. Separate collecting systems are
usually in place for disused electronic and
electrical products. Please dispose of
these units at an environmentally
compatible recycling facility, per
European Directive 2002/96/EC.
Environmental s s tatement - Bosch has a strong
commitment towards the environment. This
unit has been designed to respect the
environment as much as possible.
Electrostatic-s s ensitive d d evice - Use proper
CMOS/MOS-FET handling precautions to avoid
electrostatic discharge.
NOTE: Wear required grounded wrist straps and
observe proper ESD safety precautions when
handling the electrostatic-sensitive printed
circuit boards.
Fuse r r ating - For security protection of the
device, the branch circuit protection must be
secured with a maximum fuse rating of 16A.
This must be in accordance with NEC800 (CEC
Section 60).
Grounding a a nd p p olarization - This unit may be
equipped with a polarized alternating current
line plug (a plug with one blade wider than the
other blade). This safety feature allows the plug
to fit into the power outlet in only one way. If
unable to insert the plug fully into the outlet,
contact a locally certified electrician to replace
the obsolete outlet. Do not defeat the safety
purpose of the polarized plug.
Alternately, this unit may be equipped with a 3-
pole grounding plug (a plug with a third pin for
earth grounding). This safety feature allows the
plug to fit into a grounded power outlet only. If
unable to insert the plug into the outlet,
contact a locally certified electrician to replace
the obsolete outlet. Do not defeat the safety
purpose of the grounding plug.
Bosch Security Systems | July 08, 2008
Moving - Disconnect the power before moving
the unit. Move the unit with care. Excessive
force or shock may damage the unit and the
hard disk drives.
Outdoor s s ignals - The installation for outdoor
signals, especially regarding clearance from
power and lightning conductors and transient
protection, must be in accordance with
NEC725 and NEC800 (CEC Rule 16-224 and
CEC Section 60).
Permanently c c onnected e e quipment -
Incorporate a readily accessible disconnect
device in the building installation wiring.
Pluggable equipment - Install the socket outlet
near the equipment so it is easily accessible.
PoE - Never supply power via the Ethernet
connection (PoE) when power is already
supplied via the power connector.
Power d d isconnect - Units have power supplied
whenever the power cord is inserted into the
power source. The powhe main power
disconnect for all units.
Power l l ines - Do not locate the camera near
overhead power lines, power circuits, or
electrical lights, nor where it may contact such
power lines, circuits, or lights.
SELV - All the input/output ports are Safety
Extra Low Voltage (SELV) circuits. SELV circuits
should only be connected to other SELV
circuits. Because the ISDN circuits are treated
like telephone-network voltage, avoid
connecting the SELV circuit to the Telephone
Network Voltage (TNV) circuits.
Video l l oss - Video loss is inherent to digital
video recording; therefore, Bosch Security
Systems cannot be held liable for any damage
that results from missing video information. To
minimize the risk of lost digital information,
Bosch Security Systems recommends multiple,
redundant recording systems, and a procedure
to back up all analog and digital information.
EN | 4