This is a safety installation or any area which is classified as a wet feature. If you are unable to insert the plug into the location. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 3
Unauthorized substitutions may result in fire, electric shock or other hazards. 20 Safety Check - Upon completion of any service or repairs to the units, ask the service technician to Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 4
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Persons can be (severely) injured, or the equipment can be seriously damaged, if the alert is not Caution, Warning, Danger observed. Icon for risk of electrostatic discharge. • Danger Not observing the alert can result in death. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Plena Easy Line Mixer, see figure 2.1 on the next page. volume and tone dial controls to indicate favorite settings for a particular application. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 10
A separate battery charger is, therefore, not required. The charger charges the battery with a 0.5 A constant current until the battery voltage reaches 27.4 VDC. figure 2. 1 : Schematic overview of the Plena Easy Line Mixer Bosch Security Systems | 2008-04 | PLE-10M2-US en...
The maximum distance is 200 m. Please refer to the relevant datasheet for more 13 Master low tone control for music inputs. 14 Zone 1 selection button. information. 15 Zone 2 selection button figure 2.2: Front panel Bosch Security Systems | 2008-04 | PLE-10M2-US en...
15 Call station input, RJ-45 connector - PLE-2CS or PLE-2CSMM, chimes are in call station. This input has second highest priority. 16 Remote control wall-panel-input, RJ-45 connector. Wall panel incorporates: BGM source selection, and zone on/off control. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 13
T1.6L250V for 115V The Netherlands PLE-2CS Volume Zone 1 Zone 2 DC In override Chime Ducking Tel/Emer. Line Music Only Wall panel 1(disc) 2(radio) 3(aux) Insert 24 25 figure 2.3: Rear panel Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 14
Plena Easy Line Mixer | Installation and User Instructions | Description en | 14 Intentionally left blank Bosch Security Systems | 2008-04 | PLE-10M2-US en...
4 feet from the bottom of the unit. plug it into the mains outlet. figure 3. 1 : Installing the unit in a rack figure 3.2: Power connection and voltage selector Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 16
Plena Easy Line Mixer | Installation and User Instructions | Installation en | 16 Intentionally left blank Bosch Security Systems | 2008-04 | PLE-10M2-US en...
See section 4.3. Note When connecting an unbalanced line level (200 mV) signal to the microphone/line input, connect it as follows: Signal to pin 2, pin 1 and pin 3 to ground. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Microphone/line input 2. Set the DIP switch settings for microphone/line input 2 as required. See section 4.3. figure 4.3: Connecting microphone inputs Bosch Security Systems | 2008-04 | PLE-10M2-US en...
(12) at the rear of the unit. For safety reasons, the volume of the emergency announcement or signal cannot be set to zero. figure 4.4: Connecting 70 Volt input signal Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 21
Never try to make a direct connection between the telephone network and the mixer. figure 4.5: Connecting emergency telephone lines Bosch Security Systems | 2008-04 | PLE-10M2-US en...
When using a CD player, tuner or other auxiliary device for background music, connect the line-out connectors of the music source to the appropriate line-in connectors of the mixer. figure 4.6: Connecting music source inputs Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Use the Pre-out, amp in insert (20) for external sound processing equipment (e.g. an equalizer or Plena feedback suppressor) to be connected between the preamplifier and the power amplifier stages. See figure 4.7. figure 4.7: Connecting music source inputs Bosch Security Systems | 2008-04 | PLE-10M2-US en...
LBC 2900/15. Background level. music and announcements will be heard in the selected zones. A chime is not available in this mode. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 25
19) are available. All other inputs, including the so that callers can listen to music Tel. emergency/70V input will be overridden. when they are put on hold. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
2 Pick up the cover, and then bend it slightly in the middle by hand. 3 Fit the cover into the slot at the front of the unit, and then gently release the cover, making sure that the paper label stays in place. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
(see figure 5.1). 2 Set the power button (1) on the front of the unit to On - pushed in (see figure 5.2). figure 5. 1 : Voltage selector Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Correspondingly, the tone controls for background music provide the most appropriate music reproduction. figure 5.2: Front panel Bosch Security Systems | 2008-04 | PLE-10M2-US en...
5.5.2 Master volume control Use the master volume control dial (7) to collectively control the sound level of all outputs, except the emergency announcement/signal. Bosch Security Systems | 2008-04 | PLE-10M2-US en...
Page 30
Plena Easy Line Mixer | Installation and User Instructions | Operation en | 30 Intentionally left blank Bosch Security Systems | 2008-04 | PLE-10M2-US en...