Connection And Mounting; Power Connection; Low Voltage Cameras - Bosch VBN-5085 Installation Manual

12 en | Connection and mounting
4

Connection and mounting

CAUTION!
Before proceeding, disconnect the power from the power
supply cable. Ensure that the voltage of the unit matches the
voltage and type of the power supply being used.
4.1

Power connection

4.1.1

Low voltage cameras

5 mm
Figure 4.1 Low voltage power connection
Connect power from a 24 VAC or 12 VDC class 2 power supply
as follows:
–
–
–
–
AM18-Q0644 | v1.0 | 2013.03
Use AWG16 to 22 stranded wire or AWG16 to 26 solid
wire; cut back 5 mm (0.2 in) of insulation.
Remove the 3-pole connector from the camera body.
Loosen the screws and insert the wires.
Note
The central connection for System (video) ground is
optional. Connecting System ground to Safety ground may
result in ground loops that can disrupt the CCTV system.
Tighten the screws and reconnect the 3-pole connector to
the camera.
Installation Manual
DINION 5000 AN
1
4
2
5
3
6
Bosch Security Systems