The following are determined:
<SCSI tuple> = b<BUS No.>t<TARGET No.>l<LUN>
<SCSI path> = d<DOMAIN No.>H<HOST No.>c<CHANNEL
No.>t<TARGET No.>l<LUN>
The tuple and path first displayed for a device, correspond to the primary path
used to access the device.
NOTE:
If an extension SCSI board is mounted in a PCI slot, topology setting is
necessary.
To confirm the software RAID, execute [Status(Raid)].
A RAID status display sample is shown below.
[Status(Raid)]
-------------------------------------------------------------
name
md0
md1
md2
md3
md4
md5
md6
-------------------------------------------------------------
name: Software RAID device name
partition: Mount point or swap. If neither mount point nor swap is displayed,
the RAID is configured, but it is not mounted as a file system.
member: Information of the members making up the RAID. Information in the
following format is displayed for each member:
(slot-number) name
If a member is in error state, the (F) mark is shown to right of the member. In
this case, the RAID needs to be repaired.
status: Status information as shown below.
DUPLEX:Normal state
RESYNCING(X.X%): Synchronization in progress. DUPLEX is displayed
when synchronization is completed.
RECOVERY(X.X%): Recovery in progress. A member for which "-" is
displayed in Column "member" is not installed yet.
SIMPLEX: RAID installed in only one system. If two members are displayed
in the column "member," the member with "-" displayed is in standby state
before the RECOVERY state. If only one member is displayed, the RAID needs
to be repaired.
ERROR: No RAID members exist.
2-12 Configuring Linux
partition
label
/boot
/boot
/usr
/usr
/home
/home
/var
/var
/
/
/tmp
/tmp
swap
/tmp
status
member
DUPLEX
(1)sda1
(4)sdd1
DUPLEX
(1)sda5
(4)sdd5
DUPLEX
(1)sda10
(4)sdd10
DUPLEX
(1)sda6
(4)sdd6
DUPLEX
(1)sda8
(4)sdd8
DUPLEX
(1)sda9
(4)sdd9
DUPLEX
(1)sda7
(4)sdd7