Water Fill - Kenmore Sears 758.144071 Quiet comfort Owner's Manual

'144070 hum. manual 11/20/00 11:48 AM_hPage 6
Water Fill
WARNING: To reduce the risk of
shock, always unplug humidifier
before cleaning or servicing.
WARNING: To reduce the risk of fire
or shock hazard, do not pour or spill
water into control or motor area.
Close the control cover. If controls
get wet, let them dry completely and
have unit checked by an authorized
service personnel before plugging in.
This humidifier is designed for use with
the water bottle located under the bottle
cover to the left of the fan assembly. The
humidifier should be positioned where it
will be operating.
To fill the whole house humidifier, close
the control cover and remove the bottle
cover. To remove the water bottle, lift the
bottle straight up and out of the cabinet.
The water bottle is designed with an "E-Z-
Fill Side-Cap". Remove the "E-Z-Fill Side-
Cap" on the side of the water bottle by
twisting counterclockwise.
Place the opening of the water bottle
under a water faucet (the bottle should fit
under a four-inch clearance faucet). Fill
with recommended mixture of cold water
and if necessary Sears Bacteriostat #42-
14900 only. Solid debris could make the
valve leak.
Install the "E-Z-Fill Side-Cap" by twisting
clockwise. Hand tighten only.
Check for possible leaks by perform-
ing the following:
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on valve cap plunger for
about one second to let out a little
water.
3. Release the plunger.
4. Listen for air bubbles. Look for leaks
around the "E-Z-Fill Side-Cap".
5. if you hear air bubbles or see leaks,
retighten the "E-Z-Fill Side-Cap" and
repeat steps 1-4.
Wipe off excess water from the bottle.
ottle Cover
Fan Assembly
Water Bottle
\
Cabinet
Turn Counterclockwise
to Remove "E-Z-Fill Side-Cap"
Cap Plunger