Pri & Bri Lt-T Mode; Making An Outgoing Call; Bri Lt-S Mode; Incoming Call Routing According To Mmc 419/420 - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
PRI & BRI LT-T Mode

Making an outgoing call

Overlap sending
You can seize a port by dialling the port number (e.g. 701). When you see SETUP ACK dis-
played on your keyset, you can dial the destination number.
Enblock sending
You can make a call through the enblock sending mode port by dialling the port number
and the destination number followed by #.
Incoming call routing
This depends on the mode of BRI/PRI set by MMC 419/420. See Table 6.
Operational mode
PRI NOR
BRI P-P NOR
BRI P-M NOR
PRI DDI
BRI P-P DDI
BRI P-M NOR
Table 6 - Incoming call routing according to MMC 419/420

BRI LT-S Mode

Note: All of the following examples are valid only after programming with the appropriate MMC. Refer
to Part 4 of this manual.
Making a call from a DCS subscriber (DGP/SLT) to an ISDN terminal attached to LT-S port
To call a terminal attached to an LT-S port, dial the MSN of the terminal. If a terminal with
MSN of 7803 is attached to 703, and you dialled 7803, a SETUP message will be sent out
through 703 with calling party number of 7803. All terminals with MSN of 7803 will alert.
Alternatively, to call a terminal (or terminals), dial the port number. This time the calling
party number of the SETUP message is vacant. All the terminals attached to that port will
alert, with no regard to MSN number.
In the above cases, dial is always sent in enblock mode.
Caution
When making a call from an S
the call is made, and if that number is not registered in MMC 424 the system will disconnect
the call.
Making a call from a terminal attached to LT-S
To call a DCS subscriber from an ISDN terminal, dial the number you want to call. It is of no
concern to the BRI card whether the terminal sends the number in enblock or overlap
mode.
Making a call from a terminal attached to LT-S port to a remote terminal through a TRK
Dial the TRK number followed by the destination number. ISDN TRK and analogue TRK op-
erate in the same way as seen from a terminal. When calling through an ISDN TRK there
Associated table
MMC 406
"TRK RING"
MMC 712
"DDI TABLE"
MMC 421
"MSN DIGIT"
terminal, take care with the CLI number. It is usually sent when
0
p
3–13
SPECIAL APPLICATIONS
Note
This table has global meaning -
applied to the ports set to DDI
Same as above
A table is required for each BRI
access
ort to a DCS subscriber (DGP/SLT)
NOVEMBER 2001