Turning On The Power (Bvm-F170A); Connecting To Power - Sony BVMF170A Operation Manual

The warm-up time is more than 30 minutes, approximately.
When the monitor is in standby mode
As the OPERATE lamp lights in red in standby mode,
press the MONITOR I/1 switch of the controller.
The OPERATE lamp lights in green and the monitor enters
operation mode.
32

Turning on the Power (BVM-F170A)

Turning on the Power
(BVM-F170A)

Connecting to Power

You can operate the monitor with AC or DC power supply.
To connect the AC power cord
1
Plug the AC power cord into the AC IN connector on
the rear panel. Then, attach the AC plug holder
(supplied) to the AC power cord.
AC power cord (supplied)
AC plug holder (supplied)
Attach the AC plug holder to the AC power cord, and connect
the cord to the AC IN connector so that the cord does not come
loose.
2
Slide the AC plug holder over the cord until it locks.
To disconnect the AC power cord
Pull out the AC plug holder while pressing the lock levers.
To connect the DC power supply
Connect the DC power supply to the DC IN 24 V - 28 V
connector.
When the AC power cord and DC power supply are
connected, the AC power supply is given preference to