Kenmore 795.7235 Use & Care Manual page 44

Grab-n-go bottom freezer refrigerator
Hide thumbs Also See for 795.7235:
Table of Contents

Advertisement

ICE & WATER
i i iil!liiiii!,!,iJ iiiii!!i !ilii iii
li,i! ii!
!! !i iili! i iili
!i i!! !i!!i!
Ice has bad taste or
Water
supply contains
minerals such
A water filter may need to be installed to eliminate
odor.
as sulfur,
taste and odor problems.
Icemaker was recently
installed.
Ice has been stored for too long.
The food has not been stored
properly
in either compartment.
The interior
of the refrigerator
needs
to be cleaned.
The ice storage bin needs to be
cleaned.
Dispensing warm
Refrigerator
was recently installed.
water.
The water dispenser has been used
recently
and the storage tank was
exhausted.
Dispenser has not been used for
several hours.
Refrigerator
is connected
to the hot
water supply.
Water
has bad taste
Water
supply contains
minerals such
or odor.
as sulfur.
Water
filter has been exhausted.
Refrigerator
was recently installed.
Icemaker shutoff: (arm/sensor)
is
obstructed.
Icemaker is making
too much ice.
NOTE: In some cases, a filter may not help. It may not
be possible to remove all minerals / odor / taste in all
water supplies.
Discard the first few batches of ice to avoid discolored
or bad tasting ice.
Ice that has been stored for too long will shrink,
become cloudy, and may develop
a stale taste. Throw
away old ice and make a new supply.
Rewrap the food. Odors may migrate to the ice if
food is not wrapped
properly.
See the Care and Cleaning
section for more
information.
Empty and wash the bin (discard old cubes). Make
sure that the bin is completely
dry before reinstalling
it.
Allow 24 hours after installation
for the water storage
tank to cool completely.
Depending
on your specific model, the water storage
capacity
will range from approximately
20 to 30 oz.
If the dispenser has not been used for several hours,
the first glass dispensed may be warm. Discard the
first 10 oz.
Make sure that the refrigerator
is connected
to a cold
water pipe.
_,WARNING:
Connecting
the refrigerator
to a hot
water line may damage
the icemaker.
A water filter may need to be installed to eliminate
taste and odor problems.
It is recommended
that you replace the water filter:
Approximately
every 6 months.
When the water filter indicator
turns on.
When the water dispenser output decreases.
When the ice cubes are smaller than normal.
Dispense 2.5 gallons of water (flush for approximately
5 minutes) to remove trapped
air and contaminants
from the system. Do not dispense the entire 2.5
gallon amount continuously.
Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
Empty the ice bin. If your icemaker
is equipped
with
an ice shutoff: arm, make sure that the arm moves
freely. If your icemaker
is equipped
with the electronic
ice shutoff: sensor, make sure that there is a clear path
between the two sensors. Reinstall the ice bin and wait
24 hours to confirm
proper operation.
44

Advertisement

Table of Contents
loading

Table of Contents