Fujitsu Solaris PCI GigabitEthernet 3.0 User Manual page 40

ndd -set /dev/fjgi 'instance' value
ndd -set /dev/fjgi 'param1' value
ndd -set /dev/fjgi 'param2' value
:
ndd -set /dev/fjgi 'adv_autoneg_cap' N (Once let Auto-Negotiation be a different
ndd -set /dev/fjgi 'adv_autoneg_cap' M (Auto-Negotiation is returned to the
example) While Auto-Negotiation had been enabled, when changing fjgi0 into 100Half
(Autonego=1, link_sppd=100, link_mode=0) from a default state (Autonego=1,
link_speed=1000, link_mode=1)
# ndd -set /dev/fjgi
# ndd -set /dev/fjgi
# ndd -set /dev/fjgi
# ndd -set /dev/fjgi
# ndd -set /dev/fjgi
# ndd -set /dev/fjgi
(Note) Please perform change and sending back of Auto-Negotiation at the end.
When setting change is reflected (an Auto-Negotiation value being subject to
change):
ndd -set /dev/fjgi 'instance' value
ndd -set /dev/fjgi 'param1' value
ndd -set /dev/fjgi 'param2' value
:
ndd -set /dev/fjgi 'adv_autoneg_cap' N (Let Auto-Negotiation be a different value
exapmle) When fjgi0 is changed into the state of 100Full where Auto-Negotiation was
disabled, from the state of 100Half (Autonego=1, link_sppd=100,
link_mode=0) where Auto-Negotiation was enabled
# ndd -set /dev/fjgi
# ndd -set /dev/fjgi
# ndd -set /dev/fjgi
(Note) Please make a change of Auto-Negotiation at the end.
● The following parameters can be used with the ndd command:
parameter
?
(Instance number "value" of an applicable
interface is specified.)
(Change 1 of a setup)
(Change 2 of a setup)
:
value from the present condition.)
original value.)
'instance' 0
'adv_1000fdx_cap'
'adv_1000hdx_cap'
'adv_100fdx_cap'
'adv_autoneg_cap'
'adv_autoneg_cap'
(Instance number "value" of an
applicable interface is specified.)
(Change 1 of a setup)
(Change 2 of a setup)
:
from the present condition.)
'instance' 0
'adv_100fdx_cap'
'adv_autoneg_cap'
status
Read only Display parameter list
3.3 Operation Mode Setup
0
0
0
0
1
1
0
meaning
33