Related Manuals for NEC Express5800/140Hb
Summary of Contents for NEC Express5800/140Hb
- Page 1 System Release Notes Express5800/140Hb System Release Notes PN: 455-01598-002...
- Page 2 Since implementation by customers of each product may vary, the suitability of specific product configurations and applications must be determined by the customer and is not warranted by NEC Computers Inc. To allow for design and specification improvements, the information in this document is subject to change at any time, without notice.
-
Page 4: Table Of Contents
Express5800/140Hb System Release Notes The Express5800/140Hb System Release Notes provide up-to-date information on your system. These notes also provide additional valuable information about your system that was not included in the user’s guide. Please read these notes in their entirety. -
Page 6: Introduction
Windows documentation for instructions. After installing Windows 2000, the Windows 2000 Device Manager may show an NEC GEM SCSI Processor Device and/or an Unknown Device under Other Devices. The Unknown Device is a reference to the baseboard management controller. Installing the ESMPRO Agent can clear both of these conditions. -
Page 7: Sco
The Administrator Menu in the System Information Management segment of the Offline Maintenance Utility is accessible only by NEC authorized service representatives. EXPRESSBUILDER operates in floppy emulation mode. The emulated floppy drive portion of your system CD-ROM is designated Drive A and the remaining portion(s) of the CD-ROM is designated Drive Q. -
Page 8: Documentation Errata
Documentation Errata The following changes apply to the Express5800/140Hb User's Guide (456-01546-000) located on the EXPRESSBUILDER CD-ROM: Chapter 3, Configuring System Board Jumpers. Replace Figure 3-2 System Jumpers with the following figure. Processor speed jumper block Battery power control/reset jumper block... - Page 9 6 Express5800/140Hb System Release Notes...