Other Error Messages - Panasonic KX-T336 Installation Instructions Manual

3.00 Other Error Messages

Error Message
Illegal parameter
Parameter is not
consecutive
This parameter
cannot assign
Duplicate parameter The number which is set previously in this
definition internal
Duplicate parameter The number which is set previously in a different Set the number different from the previous
definition external
Not installed
Invalid status
Diagnostic failure
Insufficient privilege
Failure
Service violation
Already accessed
by another device
Printer is not ready
Cannot print out in
remote
Waiting
Calender IC trouble
Device error
Version error
Checksum error
Technical Manuals Online! - http://www.tech-man.com
Probable Cause
Unacceptable value is assigned.
Space exits between items.
Assigned selection value is not for the item.
screen is assigned again.
screen is assigned.
Device is not installed
Status of the specified device does not accept
this command.
Diagnostic error is checked when In-Service
command is executed.
Privilege level is lower than specified level.
Port test is made during a card malfunction.
Specified service is not executed.
Another maintenance device (remote, PITS,
system) is in use.
Printer is not connected to the system or the
power is off.
Print out is unavailable from Remote.
Changing of program data is suspended
because call placement is going on.
Calendar IC malfunction.
Backup device is not connected (only when
maintenance device is ATT).
Different version at the time of backup.
A checksum error has been detected.
Assign an allowable value.
Remove the space.
Set the assignable
Set the number different from the previous
number.
number.
Assign the installed device.
Change the status of the device to be
acceptable for the command.
Execute test.
increase the privilege level through the
Change level function.
Repair the malfunctional card.
Check specified service.
Wait until another device is finished or let him
finish.
Connect the printer, and make the power on.
Execute print out on-site.
Wait for a while or cancel the setting by
Repair calender IC.
Connect the backup device to SIO # 1 Port.
Match the backup version.
Communication line is defective, or backup
data is destroyed.
9-M-7
Countermesure
value.
I