[:Sense]:Tinterval Subtree (Hp 53131A And Hp 53132A With S/N Prefix Below 3646); [:Sense]:Tinterval:arm Subtree (Hp 53131A And Hp 53132A With S/N Prefix Below 3646) - HP 53131A/132A 225 MHz Programming Manual

Chapter 4 Command Reference
Introduction
[:SENSe]:TINTerval Subtree (HP 53131A and HP 53132A With
S/N Prefix Below 3646)
This subtree controls the time interval (including Time Interval, Risetime,
Falltime, Duty Cycle, and Pulse Width functions) measuring capabilities of the
instrument. Refer to page 4-98, for Time Interval arming capabilities of the
HP 53132A with a serial number prefix 3646 and above.
[:SENSe]:TINTerval:ARM Subtree
With S/N Prefix Below 3646
This subtree is use to synchronize the time interval start and stop arm with events.
The following combination of start/stop arming sources are valid:
STARt:SOURce
IMMediate
IMMediate
EXTernal
EXTernal
[:SENSe]:TINTerval:ARM[:STARt]:SLOPe POSitive | NEGative
Sets or queries the slope of the external start arm signal used in external arming
time interval (including Time Interval, Risetime, Falltime, Duty Cycle, and Pulse
Width functions) measurements.
Query Response
A sequence of ASCII-encoded bytes: POS or NEG
Comments
Related
Gate & ExtArm
Front-Panel
Keys
Programming Guide
STOP:SOURce
IMMediate
TIMer
IMMediate
TIMer
*RST: POSitive
Only applies when [:SENS]:TINT:ARM[:STAR]:SOUR EXT is selected.
(HP 53131A and HP 53132A
)
Front-Panel Arming Settings
ARM
AUTO
AUTO
EXTERNAL
EXTERNAL
DELAY
NONE
TIME
NONE
TIME
4-95