Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele DA 5294 W
Summary of Contents for Miele DA 5294 W
- Page 1 Operating and installation instructions Cooker hood DA 5294 W DA 5294 W EXT en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ - Page 3 Contents Electrical connection ..........36 Operation with Control module DSM 400 .
-
Page 4: Caring For The Environment
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled. -
Page 5: Warning And Safety Instructions
Any other usage is not supported by requirements. Inappropriate use the manufacturer and could be can, however, lead to personal injury dangerous. Miele cannot be held liable and damage to property. for damage resulting from incorrect or improper use or operation. -
Page 6: Technical Safety
Faulty components must only be the appliance could be damaged. replaced by genuine Miele original Consult a qualified electrician if in any parts. The manufacturer can only doubt. guarantee the safety of the appliance... - Page 7 These models may only be combined with a Miele external motor. This appliance must not be used in a non-stationary location (e.g. on a ship). Great care should be taken when...
- Page 8 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heating appliance are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 9: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... -
Page 10: Correct Installation
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use. -
Page 11: Modes Of Operation
Modes of operation . . . air recirculation: The cooker hood works with (this requires an optional conversion kit and charcoal filter: see "Technical Data") . . . air extraction: The air is drawn in and cleaned first by The air is drawn in and cleaned by the the grease filters and then by a grease filters and directed outside. -
Page 12: Description Of The Appliance
Description of the appliance... -
Page 13: Description Of The Appliance
Description of the appliance Telescopic extension piece Operating hours control Tower The indicator lamp for the operating hours control lights up red when the Canopy grease filters need to be cleaned. Grease filters The indicator lamp lights up blue when Charcoal filter the charcoal filter used in recirculation mode needs to be replaced. -
Page 14: Miele|Home
Miele electric of the cooker hood. hob with onset controls. This module must be installed by a... -
Page 15: Operation
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off control. ^ To set this option, both the fan and The fan will come on at power level "II". -
Page 16: Run-On Option
Operation Run-on option It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction I and IV will flash if the automatic or recirculation mode. -
Page 17: To Switch The Hob Lighting On
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to switch on the hob lighting. -
Page 18: Filter Operating Hours Counter
Operation Filter operating hours counter Reading the operating hours counter for the grease filters The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filters or charcoal filter need to be cleaned or replaced. - Page 19 Operation Altering the operating hours counter for the grease filters You can set the operating hours counter for the grease filters to suit the The – / + indicator lamps show the time type of cooking you do. which has been set: –...
- Page 20 Operation Activating and altering the operating hours counter for the charcoal filter (only for recirculation mode) The charcoal filter is needed for ^ Confirm the selection by pressing the recirculation mode. operating hours control. On delivery, the operating hours All the indicator lamps will go out. counter for the charcoal filter is switched off, and is set at unlimited.
- Page 21 Operation Reading the operating hours counter for the charcoal filter To check the percentage of time set already used: ^ Press the On/Off control to switch the fan on. ^ Press the operating hours control twice in succession, and hold it pressed in.
-
Page 22: Cleaning And Care
Cleaning and care ^ Wipe the surfaces dry using a soft A range of Miele branded cleaning and conditioning products is available to cloth. order from Miele (see back page for Do not use too much water when details) or via the internet at cleaning the controls. -
Page 23: Grease Filters
Cleaning and care Grease filters Important for appliances with lacquered housing The re-usable metal grease filters in the appliance remove solid partilces from (special order finish) the kitchen vapours (grease, dust etc), It is very difficult to clean this type of preventing soiling of the cooker hood. - Page 24 ^ After replacing the grease filters, ^ Do not wash at more than 65° C. If a press the operating hours control for Miele dishwasher is being used, approx. 3 seconds to reset the select the Sensor wash programme. operating hours counter.
-
Page 25: Fitting And Replacing The Charcoal Filter
New filters can be purchased from – the indicator lamp for the operating your Miele dealer or from the Miele hours control lights up blue, Spare Parts Department. See back cover for contact details, and "Technical data" for the model –... -
Page 26: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off. Let them cool down before you change them. -
Page 27: After Sales Service
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer / Chartered Agent please contact Miele. See back cover for contact details. In the U.K. your appliance is –... -
Page 28: Appliance Dimensions
Appliance dimensions 1) Extraction Connection for air extraction ø 150 mm, or ø 125 mm with reducing 2) Recirculation collar. 3) Ventilation grille positioned at the top for recirculation 4) and 5) (4 is for recirculation mode only): The shaded areas represent the wall or ceiling area for the vent cut-out and for fitting the connection socket. -
Page 29: Safety Distance Between Hob And Cooker Hood (S)
If this cooker hood is installed above – The height of the cooking appliance a Miele Wok CS 1028 CombiSet must be taken into account when appliance, a minimum safety planning the installation height of the distance of 760 mm must be cooker hood. -
Page 30: Installation
Installation Assembly parts... - Page 31 Installation 3 protective sheets for use when fitting the tower. 1 exhaust connection for exhaust 6 screws 5 x 40 mm and ducting C 150 mm. 6 x S 8 plugs 1 reducing collar for securing the wall bracket. for exhaust ducting C 125 mm. The screws and plugs are 1 non-return flap designed for use in solid walls only.
-
Page 32: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 33: Connection For Air Extraction
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as... -
Page 34: Condensate Trap
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent (available as an optional accessory) is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue. -
Page 35: Silencer
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit ...in recirculation mode: The silencer needs to be positioned... -
Page 36: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 37: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 control module can Components used in the central be used to combine the cooker hood ducting system are not supplied by with other components. Miele. It enables the following: If in any doubt, the advice of a... -
Page 38: Technical Data
Weight DA 5294 W ....26 kg Level I ....180 m DA 5294 W EXT . - Page 40 Alteration rights reserved / 3011 M.-Nr. 09 203 000 / 00...