Reconfiguring The Agent On Hp-Ux Operating Systems; Uninstalling Components From Windows® Systems - HP UPS User Manual

•
Change any items that should be unique, such as the Management Server IP address, through the
normal operation of the software.
To install the agent on a system running HP-UX using the silent installation method:
Create a temporary directory.
1.
Copy the following files into the temporary directory you just created:
2.
DevManRA.ini—During an assisted install, this file is landed in the same folder in which the
o
agent is installed.
EULA—This file is included with the installation files on the HP Infrastructure Management Pack
o
CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower).
SetupRA—This file is included with the installation files on the HP Infrastructure Management
o
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower).
Uninstall—This file is included with the installation files on the HP Infrastructure Management
o
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower).
HPRA4.5Buildx.depot—This file is included with the installation files on the HP Infrastructure
o
Management Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower).
From the directory that contains all five files, run ./SetupRA -s -f DevManRA.ini to install
3.
silently.
If the .ini file is not located in the same folder as the SetuprRA file, run ./SetupRA -s -f
<path> DevManRA.ini, where <path> is the DevManRA.ini file location.
The following command line parameters can be specified and are applicable for both interactive and
silent modes.
Parameter
-s
-l
-f DevManRA.ini

Reconfiguring the agent on HP-UX operating systems

To reconfigure the management module IP address or serial path, run /sbin/init.d/DevMan setup.
Uninstalling components from Windows® systems
Click Start>Settings>Control Panel.
1.
Function
Specifies a silent install.
Creates an installation log
(opt/DevMan/install.log). Default is disabled for
interactive mode and enabled for silent mode.
The installation log is created automatically for
Windows® during silent installations in
\%systemdrive%\setup.log.
Specifies a configuration .ini file used for clean
installs. When this option is specified, the device
detection and configuration step is omitted.
Installing the HP UPS Power Protection Agent 40