GE Appliances JV936 Owner's Manual And Installation Instructions page 16

Installation Instructions
D INSTALL MOTOR
Motor Attachment
. Align and engage the slots
Bracket
in the blower assemlyto _-----_
the 3 hooks at the rear of _ __
theexhaust opening. _
I I
. Rotate motor uplards until it I ] I I [ I I /
aligns with the attachment I _J J_-r j I I
screw location. _ I
. Secure the motor to _Motor Hooks
attachment bracket at
thefront oftheopening __ .....
with washer and screw __
provided.
___JL
. Plug the motor
connector into the
_z__-_- n_
mating hood connector.
Seethe illustration for
the hood connector location. Touch
the hood to locate and make the
connection.
IMPORTANT : Hold the connector so
the two square corner terminals are
at the top as you position the connector
to plug it in.
CONNECT ELECTRICAL
Verify that power is turned off at the source.
J::LVV_I_i_i I i_: If house wiring isnot 2-wire
with a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure to use
UL approved anti-oxidant compound and aluminum-to-
copper connectors.
A
Remove
Junction Box C Insert Power
Cover Conduit thru Strai_
Relief and Tighten _
........ , ........... dh_ite
Ground .......... /Black
B Check that White, Black and j__ _1
Gree HoodWiresareThreaded l U_[ _ F_"_ - I
thru Small Hole in Bracket. I _ J
D Use UL Listed Wire Nuts
. Use wire nuts to connect incoming ground to green,
white to white, and black to black.
, Push wires into junction box and replace cover. Be
sure wires are not pinched.
INSTALL DUCT COVERS
To install the 12" duct cover alone:
, Place the 12" section of the decorative duct cover on
top of the hood.
, Secure the cover on the top of the hood with 4 screws
provided.
To install the 2-piece duct cover:
, Place the 2-piece duct cover on the top of the hood.
, Secure the bottom cover to the top of the hood with 4
screws provided. See illustration, page 16.
, Extend the inside section upwards to meet the ceiling
and ceiling bracket
, Secure the duct cover to the bracket with the 2 small
Phillips screws provided.
INSTALL FILTER SUPPORT
e
e
Tip filter support into the rear of the hood.
Insert support tabs into the slots at the rear of the
hood.
, Secure the support to the hood with screws as
shown..
16