Sony BDV-E980 Manual page 67

Picture
Symptom Problems and solutions
There is no picture. • Check the output method on your system (page 22).
There is no picture when you • The unit is connected to an input device that is not HDCP (High-bandwidth
make an HDMI cable Digital Content Protection) compliant ("HDM]" on the front panel does not
connection, light up) (page 22).
3D images from the HDMI (IN • Depending on the TV or video component, 3D images may not appear.
1) or HDMI (IN 2)jack do not
appear on the TV screen.
Them is no picture or output • When playing a BD-ROM, a high-resolution image may not be output because
resolution is low when you make of copy protection limitations. We recommend to make a HDMI connection
a component video cable (page 22).
connection.
No picture appears when the • Press and hold _ and VOL - on the unit for more than 5 seconds to reset the
vide() output resolution selected vide() output resolution to the lowest resolution.
in IOutput Vide() Format] is
incorrect.
The dark area of the picture is too • Set [Picture Quality Mode] to [Standard] (default) (page 41 ).
dark/the bright area is too bright
or unnatural.
The picture is not output • Check the [Output Video Format] settings in [Semen Settings] (page 58).
correctly. • If the analog and digital signals are output at the same time, set [BD/DVD-
ROM 1080/24p Output] in [Screen Settings] to [Off] (page 59).
• For BD-ROMs, check the [BD/DVD-ROM 1080/2@ Output] settings in
[Screen Settings] (page 59).
Picture noise appears. • Clean the disc.
• If the picture output from your system goes through your VCR to get to your
TV, the copy-protection signal applied to some BD/DVD programs could affect
picture quality. If you still experience problems even when you connect your
unit directly to your TV, try connecting your unit to the other input jacks.
An image is not displayed on the • Check the setting of [TV Type] in [Screen Settiugs](page 58).
entire TV screen. • The aspect ratio on the disc is fixed.
Color irregularity occurs on the • If the speakers are used with a CRT-based TV or projector, install the speakers
TV screen, at least 1.0 ft (0.3 meters) from the TV set.
• If the color irregularity persists, turn ofl' the TV set once, then turn it on after 15
to 30 minutes.
• Make sure that no magnetic object (magnetic latch on a TV stand, health care
device, toy, etc.) is placed near the speakers.
• Select the input on your TV for this system. There is no picture after playing
a video/photo file on the iPodi
iPhone. (U.S. and Canada
models only.)
O.
O.
u.
o
-,I
o
o
67 us