Panasonic AF-FX100 Setup Instructions page 65

Variable name
5 CameraFrameRate
6 CameraResolution
7 KanshiServerCameraAddr
8 OriginalAlarmIpAddr
9 OriginalAlarmPort
10 TokuIpAddr
11 BoxServerCameraPort
12 KanshiServerCameraPort
Message
Camera frame rate
setting (frame per sec-
ond).
"0" use camera default
frame rate
Camera resolution
setting values defined in
CGI spec sheet(typically,
horizontal pixels).
"0" use default
camera image resolu-
tion
ip_address of kanshi_
server camera netwark
original alarm notification
PC ip_address*(MAX:8)
original alarm notification
PC port
IP address of face recog-
nition pc
port of box_server cam-
era network
port of kanshi_server
camera network
65
Settings Description
Fixed The number of Input images from
a camera is specified. "10" fixed
for all libraries.
Setting value: 10 fps
* Set to 10 fps (sheets/sec.) at
the camera side.
Fixed The resolution of input images
from a camera is specified. "0"
fixed for all libraries.
Setting value: 0
* Specify the value at the camera
side (VGA).
Mandatory The IP addresses of PCs on
which the PC software package
is installed are specified.
E.g.: 192.168.10.30
Optional Up to 8 IP addresses of
DG-ND400 or PCs on which
DG-ASM100 is installed can be
registered. *
Unless otherwise specified, leave
this blank.
When an alarm is detected, noti-
fication is performed.
E.g. 1: 192.168.10.31
E.g. 2：192.168.10.32
Fixed This is the port number for send-
ing "original alarm". The default
is "1818".
Setting value: 1818
Fixed Unused.
Fixed This is the port number of the
server at the BOX side to com-
municate with the PC software
package. "10000" fixed.
Setting value: 10000
Fixed This is the port number of the
server at the PC software pack-
age side to communicate with
the BOX. "15000" fixed.
Setting value: 15000
1