Table of Contents
Advertisement
REMOTE CONTROL OPERATION
(FOR
MODEL
PT-47WX34
ONLY)
Programming
The Remote Control
The Universal
Remote Control
can be programmed
to
operate
many
manufacturers'
components,
using
the
component
function
buttons
for VCR,
DVD, CABLE
or
DBS. Follow the procedures for programming your Remote
Control with or without a code for the component.
DVD
DMD(Preset)Panasonic
C0de
Note:
Determine the manufacturer
of the component and look
in the table for the code (found on page 15}.
Procedure
1.
Confirm that the external component
is plugged in and
operating.
2.
Turn the component off.
ACTION
3.
Press
O
and O
together,
for at least
5
seconds.
After
5 seconds,
the
illuminated
mode
(component)
buttons will begin to flash. Release
the
ACTtON and POWER buttons.
4.
Press appropriate
component
button on the Remote
Control VCR, DVD, CABLE
or DBS. The component
button will illuminate steadily and all others will go out.
5.
Enter the 3-digit component
code using the Remote
Control numeric keypad (0 ~ 9 buttons). The component
button will blink twice.
6.
Press
the
Remote
Control
to
test
the
component.
If
the
procedure
was
successful,
the
component will turn on and the component
key will blink
twice and then go out.
Note:
If the component
does not operate
with the Remote
Control, repeat the steps 3 through 6 using another code
(some brands have multiple codes.). If an incorrect code
is entered,
or if the procedure
takes longer
than 30
seconds, the programming
will fail.
Programming
Without
A Code
This
procedure
searches
all
codes
and
is called
the
%equence
method."
1.
Confirm that the external component
is plugged in and
on.
2.
Turn the component off.
ACTION
3.
Press
O
and
together,
for at least 5
seconds.
After
5 seconds,
the
illuminated
mode
(component)
buttons will begin to flash. Release
the
ACTtON and POWER buttons.
4.
Press appropriate
component
button on the Remote
Control. The component
button will illuminate
steadily
and all others will go out.
5.
Press the _
button to set the remote control into
the step and set mode.
6.
Point the remote control towards the component.
7.
Press VOL I_ (the mode key will blink three times), then
the Remote Control
O
button to test the
press
component. Continue this process until the proper code
is found, ff the procedure was successful, the component
will turn on.
Note:
Each time you press the VOL I_ bul_on, make suro thai lhe
componen_ key blinks twice before pressing lhe POWER
bul_on.
ACTfON
8.
Once the device responds,
press
_
to store the
code. The mode (component) button will blink twice.
Note:
it may take many
attempts before
the correct
code
is found. If you miss a code, press <1 VOL
then press
the _
button to test the component.
Cam ponent
Codes
The Universal
Remote Control
is capable
of operating
many component
brands
after entering
a code. Some
components
may not operate because the codes are not
available
due to limited memory. The Universal
Remote
Control does not control all features found in each model.
VCR
CABLE
DVD
iiiiiiiii iiiiiiii iiiiiiii iiiiiii
....... DBS
14e
Advertisement
Table of Contents
