Epson PowerLite S4 User Manual page 69

Important Safety Instructions
◗ The lamp is fragile, and can easily break. If the lamp breaks, handle the
projector with extreme care to avoid injury from broken glass, and contact
Epson for repairs (see page 57). Particular care should be taken when the
projector is installed to a ceiling, as small pieces of glass may fall down
when the lamp cover is removed. Be very careful not to allow such pieces
of glass to get into the eyes or mouth.
◗ Material or paper may get stuck against the air filter underneath the
projector while it is in use. Remove anything from underneath the projector
that might get stuck against the air filter in this way.
◗ Never try to remove the lamp immediately after use. Doing so will result in
serious burns. Before removing the lamp, turn off the power supply and
wait the time specified in the User's Guide to allow the lamp to cool
completely.
◗ A mercury lamp with high internal pressure is used as the projector's light
source. Mercury lamps may make a loud noise when they break. Handle
the lamp with extreme care while observing the following. If the following
points are not observed, injury or poisoning may result.
◗ Do not damage the lamp or subject it to any impacts.
◗ Do not use the lamp after the lamp replacement period has elapsed.
Once the lamp replacement period has elapsed, the possibility of the
lamp breaking becomes greater. When the lamp replacement message
appears, replace the lamp with a new one as soon as possible.
◗ The gases inside mercury lamps contain mercury vapor. If the lamp
breaks, immediately ventilate the room to prevent the gases that are
released when the lamp breaks from being inhaled or coming into
contact with the eyes or mouth.
◗ Do not bring your face close to the projector while it is in use, in order to
prevent the gases that are released when the lamp breaks from being
inhaled or coming into contact with the eyes or mouth.
◗ If the lamp breaks and needs to be replaced with a new lamp, contact
Epson for information on replacement (see
breaks, pieces of broken glass may get scattered around inside the
projector.
◗ If the lamp breaks and gas from the lamp or fragments of broken glass are
◗
◗ If there is an electrical storm, do not touch the power plug, otherwise you
◗ If using a remote control that takes batteries, keep these batteries out of
◗ If the batteries are swallowed, seek medical assistance immediately.
◗ When replacing batteries, take the following precautions.
WARNING: The cords included with this product contain chemicals, including
lead, know to the State of California to cause birth defects or other
reproductive harm. Wash hands after handling. (posted in accordance with
page 57). If the lamp
Proposition 65 in Cal. Health & Safety Code § 25249.5 et seq)
◗ Particular care should be taken when the projector is installed to a
ceiling, as small pieces of glass may fall down when the lamp cover is
removed. If cleaning the projector or replacing the lamp yourself, be
very careful not to allow such pieces of glass to get into the eyes or
mouth. In addition, consult your local regulations regarding proper
disposal and do not place in the trash.
inhaled or get into the eyes or mouth, or if any other ill effects are noticed,
immediately seek medical advice.
This product includes a lamp component that contains mercury (Hg).
Please consult your state and local regulations regarding disposal or
recycling. Do not put in the trash.
may receive an electric shock.
the reach of children. Batteries are choking hazards and can be very
dangerous if swallowed.
◗ Replace the batteries as soon as they run out.
◗ If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets
on your hands, wash immediately.
◗ Do not expose batteries to heat or flame.
◗ Dispose of used batteries according to your local regulations.
◗ Remove the batteries if you won't be using the projector for a long
period of time.
69