Teach Pendant Connection - Epson RC170 Manual

3.4 Teach Pendant Connection

(1) Disconnect the Bypass Plug connected to the Operator Panel.
(2) Connect the connector of the Teach Pendant to the Operator Panel and secure it tightly.
NOTE
(3) Make sure that the Teach Pendant starts up.
(4) Make sure that the EMERGENCY STOP switch of the Teach Pendant operates.
When nothing is connected to the TP/OP port of the Controller, the Controller status will be
NOTE
Emergency Stop status. Connect the TP/OP Bypass Plug when the Teach Pendant or the
Operator Panel is not connected.
NOTE
Connection and disconnection of the Teach Pendant is available when the Controller in ON.
Make sure to disconnect while the Controller power in OFF.
OP1 Rev.1a
Make sure to screw in the connector tightly to ensure dust-proof and drip-proof
performance.
3. Installation
13